1. press the up/down button until the "lock" flash
2. press the "edit" button. About 5mm deep until the "out A" flash
3. "SPEC" flash. Press "edit"
4. Threshold value comparator flash, press "edit:
5."SP" flash, used up/down button set to -0.300, press "edit"
6. "HY" flash, used the up/down button set to -0.250, press "edit"
7. "NO" flash, press "edit"
8. press "edit" button for 3 sec switch to run mode
Threshold value comparator flash
SP -0.300
HY -0.250
NO (normal open) FLASH
1
1.按下 up/down 按钮,直到 "lock"闪烁
2.按下 "edit"按钮,大约5毫米深,直到 "out A" 闪烁
3. "SPEC"闪烁,按下"edit"
4.阀值仪(应该是某种可以显示临界值的仪表)闪烁,按下"edit"
5."SP" 闪烁,用按钮 up/down 将值调节到-0.300,按下 "edit"
6."HY"闪烁,用按钮 up/down 将值调节到-0.250,按下 "edit"
7. "NO"闪烁,按下 "edit"
8.按下 "edit"按钮三秒钟,界面调到运行模式,阀值仪显示
SP -0.300
HY -0.250
NO (normal open正常开启) FLASH
1追问
2.按下 "edit"按钮,大约5毫米深,直到 "out A" 闪烁
3. "SPEC"闪烁,按下"edit"
4.阀值仪(应该是某种可以显示临界值的仪表)闪烁,按下"edit"
5."SP" 闪烁,用按钮 up/down 将值调节到-0.300,按下 "edit"
6."HY"闪烁,用按钮 up/down 将值调节到-0.250,按下 "edit"
7. "NO"闪烁,按下 "edit"
8.按下 "edit"按钮三秒钟,界面调到运行模式,阀值仪显示
SP -0.300
HY -0.250
NO (normal open正常开启) FLASH
1追问
谢谢
温馨提示:答案为网友推荐,仅供参考